Working table picture

After purchasing the drill press table, some musicians who have been visiting the center want to know how we use it. To answer the question, I have asked the workers to show them this Thursday.  A regular drill press tool is created to offer support to medium-sized metal and wood pieces.

In case you wish to handle huge samples, it is deserving to buy a drill press board. In this manner, you can set your specimen on the board and not be bothered about it sliding or falling off. Join the drill presses metal base to the drill press table by use of lag bolts for additional stability. Make use of the inbuilt clamps of the board to secure your samples into place. The drill press is mainly created to dig holes into wood or metal. However, use a drill press can enhance the accuracy and kinds of openings that you create.

A board that can bend will give room for additional and accurate angle drilling. That is why it is good to buy or build a drill press board using a dual-layered surface. This is so that the top layer may be taken away and substituted once it is worn out due to constant use. Also, the dual coating makes the board stiff and rigid even more. In case you are constructing the drill press board by yourself, make the replacement pieces read for the top of the board and cut them simultaneously.

Wood working place

A flexible hardwood fence on the drill press table needs to slide across T-shaped grooves to the left and right and also backward and forward. The wall consists of support braces to attach the fence considerately to the board at the point of drilling. Inbuilt stops may be fixed to the fence so you can create specific hole patterns like for chain or doweling drilling. Every stop is a piece of wood that has an indexing layer on a single side to match into the T paths of the board. Store spare wrenches, chuck eyes, and bits in your drawers under the drill press to make it easy to access them.

Drill vertical holes using scrap wood jig

There is a fast-fix jig that comes in handy whenever you wish to create vertical openings in the work pieces end. To generate the clamp block, ensure you cover  2 2X4, 1 9 inches long and the other one seventeen inches long. After that combine the sides that front the drill press board and the workpiece to achieve the ideal ninety-degree angle.
After that, join the faces and edges of the 11/2 X 2X10 inches fence to correct ninety degrees angles. Make use of a framing square to arrange the 2 parts at ninety degrees. The next thing is to fasten the fence to the lock block using glue and 4 8X21/2 wood screws that are flathead and stick a 150-grit sandpaper piece to the lock. After that lock, the jig yo your drill-press table, lock the workpiece to your jig, and that is all. You can now dig the hole.